Beisler 100-68 - Manual (Page 110)

21 Clamp speed
Speed of the main clamp when moving to the feeding position.
Input:
Factory setting: 90%
22 Bobbin thread counter on/off or thread length full bobbin
This function can be switched on and off.
Input 00: Bobbin thread monitoring on.
With this setting the bobbin thread counter
is deactivated automatically.
01-99: Thread length full bobbin
23 Thread trimmer speed
Positioning speed for thread trimming systems.
Input:
250 rpm
24 Thread trimmer position
Correction of the start of the thread trimmer impulse.
The smaller the set number, the earlier the bobbin thread trimmer will
start.
Input: 01 - 59
Factory setting: 45
25 Thread trimming duration
The duration of the bobbin thread trimming should be as short as
possible, because otherwise the main clamp will be moving already.
Input:
Factory setting: 0.1 sec
26 Thread tension
Number of stitches until the needle thread tensions close after the
sewing start.
Input:
Factory setting:
Setting the machine parameters
Go to the technician level via the code number.
(for Beisler service personnel only)
26