Beisler 100-68 - Manual (Page 50)

3. Transport clamps
3.1 Transport clamp stroke
Caution: Risk of injury!
Switch the main switch off.
Check and adjust the transport clamp stroke only with the sewing unit
switched off.
Standard and checking
When the flap clamps 3 are closed, the raised transport clamps 1 and 2
must pass the machine arm without hitting it.
The distance between the front edges of the raised transport clamps
and the fabric sliding sheet should amount to 28 mm on the left and on
the right.
– Push the transport carriage under the machine arm.
– Check the stroke of the two transport clamps.
Correction
–
Loosen screw 4.
– Adjust the height of the transport clamps.
– Tighten the screws 4.
12
3 2 1 4