Beisler 100-68 - Manual (Page 115)

Testing output elements
– Change between the basic module and the CAN node with the icon
“CAN”.
Y1 or Y101 is displayed.
– Select the desired output with the icon “+” / “-”.
or
– Tap on icon “Y1” or “Y101”.
– Enter the code number of the desired output element (see tables).
– Tap the key “OK”.
The output element is switched on.
The display 1 shows a “+”.
– Tap the key “OFF”.
The input element is switched off.
The display 1 shows a “-”.
– Actuate the key “Auto”.
The output element is red-shadowed and actuated in interval
mode.
Output elements machine head unit (DAC3-X120b)
Valve Designation
Y1 Needle thread catcher
Y2 Centre knife impulse
Y3 Centre knife tappet
Y5 Bobbin thread trimmer
Y6 Thread lifting
Y7 Needle disengagement, left
Y8 Needle disengagement, right
31
4
1