Beisler 100-68 - Manual (Page 102)

9 Stitch length main seam
Via this parameter the stitch length within the seam is set.
Input: 0.5 - 3.5 mm
Factory setting: 2.4 mm
10 Stitch length seam end
Via this parameter the stitch length at the seam end is set.
It affects bartacks and condensed stitches at the seam end.
Input: 0.5 - 3.0 mm
Factory setting: 1.5 mm
11 Seam section stitch length at the seam beginning
Seam section with stitch length of parameter “stitch length at the seam
beginning”
Input: 0.5 - 99 mm
Factory setting: 10 mm
12 Seam section stitch length at the seam end
Seam section with stitch length of parameter “stitch length at the seam
end”
Input: 0.5 - 99 mm
Factory setting: 10 mm
13 Bartack length at the seam beginning
Via this parameter the bartack length at the seam beginning is set. If
this value is set to 0, it is automatically sewn with condensed stitches.
Input: 0 - 20 mm
Factory setting: 10 mm
14 Bartack length at the seam end
Via this parameter the bartack length at the seam end is set. If this
value is set to 0, it is automatically sewn with condensed stitches.
Input: 0 - 20 mm
Factory setting: 10 mm
15 Slant at the seam beginning
Via this parameter the slant at the seam beginning is set.
Offset seam (difference left/right needle) át the seam beginning.
Input: 0 - 10 mm
Factory setting: 3 mm
16 Slant at the seam end
Via this parameter the slant at the seam end is set.
Offset seam (difference left/right needle) at the seam end.
Input: 0 - 10 mm
Factory setting: 3 mm
18