Beisler 100-68 - Manual (Page 47)

2.2.1 Distance between switching screw and limit switch
Checking
–
Push the transport carriage 7 to the front until the switching screw
4 is located under the limit switch 1.
– Check the distance of 1 mm between limit switch 1 and switching
screw 4.
Correction
–
Loosen the counternut 3 at the switching screw 4.
– Adjust the height of screw 4.
Distance between switching screw and limit switch = 1 mm.
– Tighten the counternut 3.
2.2.2 Front end position of the transport carriage
– Push the transport carriage 7 to the front until the switching screw
4 is located under the limit switch 1.
– Measure the distance between the needles and the fronts of the
transport clamp.
This must amount to 325 mm.
– Adjust the limit switch 1 in the slotted hole accordingly.
2.2.3 Stop guide for the transport carriage
Checking
–
Push the transport carriage 7 to the front until the surface of the
switching screw 4 is located centrically above the limit switch 1.
– Check whether in this transport carriage position the distance
between the stop guide 6 and the transport carriage amounts to 2
mm.
Correction
–
Push the transport carriage to the front until the surface of the
switching screw 4 is located centrically above the limit switch 1.
– Loosen the counternut 5.
– Approach the stop guide 6 to the transport carriage by 2 mm.
– Tighten the counternut 5.
9
3