Beisler 100-68 User Manual

Page 66

Trimming and clamping device for the needle threads

5.1

Function

Caution: Risk of injury!

Switch the main switch off.

Check knife and thread catcher only with the sewing unit switched off.

Function
–

The cylinder 2 is switched on after the seam end and during the
feed to the corner knives.
The thread catcher 3 lowers and takes the needle threads up.

–

After a preset time the thread catcher shoots up.
The needle threads are clamped at the clamping piece 1 and cut off
by knife 4.

–

After the first stitches of the next seam the clamped needle threads
are released.

–

By means of the springy clamping sheet 1 the thread catcher 3
abuts flat on the knife 4. Thus, the knife is automatically in parallel
position.

Function check
–

Call up the adjustment and test program “Selecting the output
elements” (see programming instructions chapter 5.6.1 Multitest).

–

Select the output element “Y1”.

–

Pull the needle threads to the back.

–

Switch the output element on and off by pressing the function key
“OK”.

–

Check whether the threads are accurately cut and clamped.