Avery Dennison 6035 Programmer Manual Rev.A 7/98 - Manual (Page 47)

7/9/98 Using ROM-DOS 6.22 2-35
P O W E R . E X E
Purpose
Conserves power on a system that has APM (Advanced Power
Management) by shutting down various subsystems (screen, disk
drives, etc.) not being used. POWER.EXE can be used in an INSTALL
command in CONFIG.SYS, in AUTOEXEC.BAT, or on the command
line.
Syntax
From command line or from AUTOEXEC.BAT:
[path]power[/C#][/D#][/P#][/S#][/H]
From CONFIG.SYS:
Install=[path]power[/C#][/D#][/P#][/S#][/H]
Remarks
To work, the APM functions required to be supported by the system
BIOS are:
Function Description
00 APM Installed
01 Connect
04 Disconnect
05 CPU idle
06 CPU busy
07 Set Power State
08 Get PM Event
For each device, you can specify the length of time the device must be
inactive before it is turned off. If you specify a length of zero for a
device, POWER.EXE disables power management for that device.