Avery Dennison 6035 Programmer Manual Rev.A 7/98 User Manual
Page 40
2-28 ROM-DOS 6.22 User Manual
7/9/98
To carry out the FILES=40 instruction, press (Y) for Yes. To
bypass the instruction select (N) for No. ROM-DOS executes the
command or bypasses it according to your instruction and then
moves on to the next command in the CONFIG.SYS file. To
bypass the confirmation prompt for the remaining instructions in
the CONFIG.SYS file and skip the AUTOEXEC.BAT file, press
commands in both startup files, press
When ROM-DOS finishes all of the commands in the CONFIG.SYS file,
you are prompted for processing the AUTOEXEC.BAT file:
Process AUTOEXEC.BAT [Y,N]?
If you select Yes (Y), all of the commands in AUTOEXEC.BAT are
processed. You are not prompted for each instruction. If you
select No (N), the AUTOEXEC.BAT file is completely bypassed.
You can also be prompted for a single CONFIG.SYS command by
using the question mark (?) prior to the equals sign (=) in the
command line. Refer to the next section for a full description of
the (?) command.
CONFIG.SYS Command Descriptions
For a complete description of each CONFIG.SYS command, see
Chapter 3.
I n s t a l l a b l e D e v i c e D r i v e r s
The device drivers described in this section can be installed using the
CONFIG.SYS device command. In addition to the following device
drivers, you can use device drivers that have been designed for DOS
and included with your hardware and custom-made special-purpose
device drivers.