Avery Dennison 6035 Programmer Manual Rev.A 7/98 User Manual
Page 39
7/9/98
Using ROM-DOS 6.22 2-27
To bypass the instructions in both your AUTOEXEC.BAT and
CONFIG.SYS files, follow these steps:
Turn on or re-start your computer by pressing ,
and wait for the following screen message:
Starting ROM-DOS...
As the above message is displayed, press
The following message is displayed:
ROM-DOS is bypassing your CONFIG.SYS and AUTOEXEC.BAT files.
Your system then continues the boot process using the basic default
configurations. You will notice differences in the way your system
behaves. For instance, installable device drivers and memory device
drivers are not loaded, and system prompts and path have default
values. If COMMAND.COM is not in the root directory, ROM-DOS may
not be able to locate it without assistance.
If you suspect that only one or two CONFIG.SYS commands are
causing problems in your system, ROM-DOS can prompt for a
confirmation before running each individual command. For this option,
follow these steps:
Turn on or re-start your computer by pressing ,
and wait for the following screen message:
Starting ROM-DOS...
While the above message is displayed, press the
message is displayed:
ROM-DOS will prompt you to confirm each CONFIG.SYS command.
For each command, ROM-DOS displays the command and a Yes/No
prompt:
FILES=40 [Y,N]?