Configuring codabar bar codes, Configuring msi bar codes -7, Configuring codabar bar codes -7 – Avery Dennison Platinum 6039 System Administrator Guide User Manual
Page 39

Configuring MSI Bar Codes
1.
To configure MSI settings, tap MSI from the Scanner Configuration
screen.
2.
Enable each bar code you need to scan.
MSI
Allows the scanner to scan MSI bar codes.
Transmit
CD
Tells the scanner to return the check digit with the data
when an MSI bar code is scanned.
Mod
10/11 CD
Scheme
Tells which algorithm to use to ensure the integrity of a
two-check digit MSI bar code.
Use 2
CDs
Tells the number of check digits that MSI bar codes
should have.
Note: Check digits are not always returned with the data.
If you choose two check digits, you must choose a
check digit algorithm.
Lengths
Sets the
length(s)
for MSI
bar
codes.
Variable, specifies that MSI bar codes can be any length.
Note: Specifying a range of lengths increases the likelihood of unsuccessful scans.
1 Fixed, secifies a single length for valid MSI bar codes. The range for Length 1 is 1
– 99. The default is 6.
2 Fixed, secifies two lengths for valid MSI bar codes. The range for Length 2 is 1 –
99. The default is 55.
3.
Tap OK to save all the settings and return to the Scanner Configuration screen.
Configuring Codabar Bar Codes
1.
To configure Codabar settings, tap Codabar from the Scanner Configuration screen.
2.
Enable each bar code you need to scan.
Codabar
Allows the scanner to scan Codabar bar codes.
NOTISEdit Tells the scanner to strip the start and stop characters
from scanned Codabar bar codes.
CLSIEdit
Tells the scanner to strip the start and stop characters
from 14-character Codabar bar codes and insert spaces
after the first, fifth, and tenth characters.
Note: The 14-character length does not include start and
stop characters.
Lengths
Sets the
length(s)
for
Codabar
bar codes.
Variable, specifies that Codabar bar codes can be any
length.
Note: Specifying a range of lengths increases the
likelihood of unsuccessful scans.
1 Fixed, specifies a single length for valid Codabar bar
codes. The range for Length 1 is 1 – 99. The default is
5.
2 Fixed, specifies two lengths for valid Codabar bar
codes. The range for Length 2 is 1 – 99. The default is
55.
3.
Tap OK to save all the settings and return to the Scanner Configuration screen.
Configuring the Scanner 5-7