Avery Dennison Platinum 6039 System Administrator Guide - Manual (Page 25)

Printing Diagnostic Labels
1. Tap Diagnostic Labels (test labels) from the Print Engine Tests screen.
2. Before you run these tests, be sure to load your supply in Non-Peel mode. Refer to the
Operator’s Handbook for more information about loading supply.
Select: The following labels print:
Information Labels
The first diagnostic (test) label shows the model number, software
version, and the printer’s configuration by packet. Refer to the
Programmer’s Manual for more information about configuration
packets. The second diagnostic label shows the model number,
software version, total number of inches printed, voltage, print
contrast, printhead resistance, number of bad dots, and memory.
Checkerboard Label Prints a label to verify that the printhead strobes
are working. If your printed sample has fewer
lines or no lines, keep the sample and call
Service.
Gray Scale Label The gray scale test checks the uniformity of the
printing. The printed sample should be
uniformly gray across the supply. If you see
voids, especially on the edges, keep the sample
and call Service.
Label w ith voids
Using Printer Diagnostics 4-3