beautypg.com

Enabling specific bar codes, Enabling specific bar codes -3 – Avery Dennison Platinum 6039 System Administrator Guide User Manual

Page 35

background image

9.

Tap the Page 2 tab at the top of the screen to continue. You see additional options.

in bar

11.

barcode. The

12.

beam when the scanner is

13.

ich is how many times to scan the same barcode to determine a

14.

good scans must occur in both

15.

ne is heard whenever a

16.

ne (.wav file) for No Scan. This tone is heard whenever a bar

18.

s and return to the Scanner Configuration screen.

10.

Set the Preamble, which specifies the characters to preface returned data from certa
codes. The Preamble can be up to twenty user-defined characters.
Set the Postamble, which is the data to be sent after each scanned
Postamble can be up to twenty user-defined characters.
Set the AIM Duration, which is the duration of the aiming
activated. The range is 0.0 - 9.9 seconds in .1-second increments (0 disables the AIM
feature). The default is 0.
Set the Linear Security, wh
successful read. The range is 1 – 4. The default is 1.
Enable Bi-Directional Redundancy, which specifies that
directions (forward and reverse) for the scan to be complete.
Use Browse to select the tone (.wav file) for a Good Scan. This to
bar code is successfully scanned.
Tap Play to hear the tone.

17.

Use Browse to select the to
code is unsuccessfully scanned.
Tap Play to hear the tone.

19.

Tap OK to save all the setting

E n a b l i n g S p e c i f i c B a r C o d e s

You must enable and disable each specific bar code type for scanning. Some bar codes require

following bar codes:

Not

e bar codes c n be printed, but not scanned.

for more

additional settings.

You can scan any of the

UPC/EAN

Codabar

Code 39

Code 93

Code 128

D 2of5

I 2of5

RSS

MSI

e: Som

a

See “Printable Bar Codes vs. Scannable Bar Codes”
information.

Configuring the Scanner 5-3