beautypg.com

About the summit 802.11g wireless card, Using the summit client utility, About the summit 802.11g wireless card -7 – Avery Dennison Platinum 6039 System Administrator Guide User Manual

Page 17: Using the summit client utility -7

background image

3.

To enable password protection, enter and confirm a new password.

To change a current password, enter the current password, then enter and confirm a
new password.

To disable password protection, enter the current password but do not specify a new
password.

4.

Tap Save, then OK.

5.

Tap X in the upper-right hand corner of the screen to return to the desktop.

A b o u t t h e S u m m i t 8 0 2 . 1 1 g W i r e l e s s C a r d

The Summit SDC-CF20G 802.11g wireless card operates at speeds of up to 11Mbps in 802.11b
mode and 54Mbps in 802.11g mode on any wireless-compatible network. You can use the
printer in Ad-Hoc (peer-to-peer) or Infrastructure (access point) wireless mode. Use the Summit
Client Utility (SCU) available on your printer to configure your wireless card to communicate
with your network.

U s i n g t h e S u m m i t C l i e n t U t i l i t y

The Summit Client Utility starts automatically when you turn on the printer and an icon appears
in the System Tray.

Note: You may need to be in Admin Mode to access wireless features.

See Chapter 2, “Administrative Tools” for more information.

Double-tap the signal strength icon

in the System Tray. You see the main SCU window.

Associated, Associated, or Authenticated), the radio type, the regulatory domain, and the driver

es

The main window shows you the active profile, current wireless status (Down, Disabled, Not

and utility version. From the main window you can also log in as administrator to make chang
to radio settings, and disable or enable the radio.

Configuring Wireless Settings 3-7