Avery Dennison Platinum 6039 System Administrator Guide - Manual (Page 15)

Note: A key indicates that encryption is enabled on the access point. You must have the
network encryption settings to connect to a protected access point.
2. Double-tap the network you need, then tap Connect in the pop-up menu. You see the
Profile Entry screen.
3. Tap Next to verify the mode, authentication, encryption, and IP configuration settings.
4. Tap Finished.
The Manage Profiles screen appears. When you connect to a network, Fusion creates a
profile for that connection. Your selected profile is shown with an access point icon.
Note: The icon indicates a connection to this profile. To connect to a different profile, double-
tap on the profile name, then tap Connect in the pop-up menu.
5. Tap X in the upper right-hand corner of the screen to return to the desktop.
Creating a Profile
You can create a new connection profile if the network you need does not appear in the list of
available profiles.
1. Tap , Manage Profiles.
2. Hold the stylus on an empty section of the screen until the pop-up menu appears.
Configuring Wireless Settings 3-5