Avery Dennison Platinum 6039 System Administrator Guide - Manual (Page 36)

Configuring UPC/EAN Bar Codes
1. To configure UPC/EAN settings, tap UPC/EAN from the
Scanner Configuration screen.
2. Enable each bar code you need to scan.
UPCA Allows the scanner to scan UPCA, UPCA+2, and
UPCA+5 bar codes.
UPCE Allows the scanner to scan UPCE bar codes.
UPCE1 Allows the scanner to scan UPCE1 bar codes.
EAN8 Allows the scanner to scan EAN8 bar codes.
EAN13 Allows the scanner to scan EAN13 bar codes.
3. For each bar code, decide if you want to tell the scanner to
return the check digit with the data when the bar code is scanned. Check the Transmit CD
box as necessary.
4. For each bar code, set the Preamble, which specifies the characters that preface the
returned data from a UPCA bar code. The choices are
♦
♦
♦ None (No Data)
SYSCHAR (System Character)
SYSCOUNT (Country Code and System Character).
Note: The USA country code is 0.
5. Tap the Page 2 tap at the top of the screen to continue.
6. Enable each bar code you need to scan.
Coupon Code Allows the scanner to scan UPCA, UPCA+2,
UPCA+5, and UPCA/EAN-128 bar codes.
Note: Set Supplemental to Auto to use this
option.
UPCE to UPCA Tells the scanner to convert UPCE bar codes to a UPCA format before
returning the data.
Note: After the conversion, your UPCA selections affect the data.
EAN Zero
Extend Tells the scanner to add 5 leading zeros to EAN8 bar codes to convert them
into EAN13 bar codes.
Bookland Allows the scanner to scan Bookland EAN bar codes.
EAN8 to EAN13 Tells the scanner to label the bar code as EAN8 or EAN13 when EAN Zero
Extend is enabled.
UPCE1 to UPCA Tells the scanner to convert UPCE1 bar codes to a UPCA format before
returning the data.
Note: After the conversion, your UPCA selections affect the data.
7. Set the Supplemental Mode for UPC/EAN bar codes, which specifies how to treat UPC and
EAN bar codes with supplemental characters (UPCA+2, for example). The choices are
Required, Ignore, or Auto. The default is Ignore.
Required The scanner scans bar codes with supplemental characters only. For
example, it scans a UPCA+2 bar code, but not UPCA.
Ignore The scanner ignores supplemental characters. For example, it scans a
UPCA+2 bar code as a UPCA.
Auto Uses scanning information as specified in Scan UPC/EAN Supplemental
Redundancy.
5-4 System Administrator’s Guide