Avery Dennison Platinum 6039 System Administrator Guide - Manual (Page 16)

a note of
Tap
3. Tap Add. You see the Profile Entry screen.
printer on the network.
5. Ad-Hoc or Infrastructure) and your country of
6. settings. The options are None, EAP-TLS, PEAP, LEAP,
7. settings. The options are Open (no security), 40- or 128-bit WEP,
8. P Address Entry method. The options are DHCP or Static. Tap Next.
de are
10. settings, if necessary.
appears on the Manage Profiles screen. If you
Set
e Fusion access password. The default is no
the password if you change it. Setting a
1.
4. Enter a profile name and SSID to identify the
The default name is 101. Tap Next.
Specify the wireless operating mode (
operation, if necessary. Tap Next.
Specify the authentication security
or TTLS.
These settings must match the network authentication settings or the printer cannot
connect. Tap Next.
Specify the encryption
TKIP (WPA), or AES.
These settings must match the network encryption settings or the printer cannot connect.
Tap Next.
Select the I
9. Adjust the radio transmission power, if necessary. The options for Infrastructure mo
Automatic and Power Plus.
When using Automatic, the printer uses the same transmit power level as the access point.
When using Power Plus, the printer uses a transmit power one level higher than that of the
access point. Tap Next.
Adjust the battery usage
11. Tap Finished.
Your new profile
are not automatically connected to your new profile, double-tap
your profile’s name, then tap Connect in the pop-up menu.
ting a Password
You can set or change th
password.
Note: Make
password restricts all access to wireless features.
, Options.
2. Selec Change Pas t sword from the drop-down menu.
3-6 System Administrator’s Guide