5 installing hardware, 4 installing hardware, Hardware preparation and installation – Artesyn MVME3100 Single Board Computer Installation and Use (June 2014) User Manual
Page 31

Hardware Preparation and Installation
MVME3100 Single Board Computer Installation and Use (6806800M28E)
31
The RTM EEPROM address switches must be set for address $AA in order for this device to be
accessible by MotLoad.
1.5
Installing Hardware
$AC
110
ON
OFF
OFF
$AE
111
OFF
OFF
OFF
Table 1-6 EEPROM Address Settings (continued)
Device Address
A(2:0)
SW1
SW2
SW3
Damage of the Product and Additional Devices and Modules
Incorrect installation or removal of additional devices or modules may damage the
product or the additional devices or modules.
Before installing or removing additional devices or modules, read the respective
documentation.
Damage of Circuits
Electrostatic discharge and incorrect installation and removal of the product can
damage circuits or shorten their life.
Before touching the product make sure that your are working in an ESD-safe
environment or wear an ESD wrist strap or ESD shoes. Hold the product by its edges and
do not touch any components or circuits.
Product Malfunction
Switches marked as “Reserved” might carry production-related functions and can
cause the product to malfunction if their setting is changed.
Do not change settings of switches marked as “reserved”.