Artesyn MVME3100 Single Board Computer Installation and Use (June 2014) - Manual (Page 13)

MVME3100 Single Board Computer Installation and Use (6806800M28E) 13
About this Manual
Overview of Contents
This manual is divided into the following chapters and appendices:
Hardware Preparation and Installation , provides MVME3100 board preparation and installation
instructions, as well as ESD precautionary notes.
Startup and Operation , provides the power-up procedure and identifies the switches and
indicators on the MVMEM3100.
MOTLoad Firmware , describes the basic features of the MOTLoad firmware product.
Functional Description , describes the MVME3100 and the MVME721 RTM on a block diagram
level.
Pin Assignments , provides pin assignments for various headers and connectors on the
MMVE3100 single-board computer.
Memory Maps , provides information on memory maps and system and configuration registers.
Programming Details , provides additional programming information including IDSEL mapping,
interrupt assignments for the MPC8540 interrupt controller, Flash memory, two-wire serial
interface addressing, and other device and system considerations.
Specifications , provides power requirements and environmental specifications.
Related Documentation , provides a listing of related Artesyn manuals, vendor documentation,
and industry specifications.
Safety Notes summarizes the safety instructions in the manual.
Sicherheitshinweise is a German translation of the Safety Notes chapter.
The MVME3100 Single-Board Computer Installation and Use manual provides the information you
will need to install and configure your MVME3100 single-board computer and MVME721 rear
transition module (RTM). It provides specific preparation and installation information, and data
applicable to the board.