Artesyn MVME3100 Single Board Computer Installation and Use (June 2014) - Manual (Page 24)

Hardware Preparation and Installation
MVME3100 Single Board Computer Installation and Use (6806800M28E) 24
1.4 Configuring Hardware
This section discusses certain hardware and software tasks that may need to be performed
prior to installing the board in a chassis.
To produce the desired configuration and ensure proper operation of the MVME3100, you may
need to carry out certain hardware modifications before installing the module.
Most options on the MVME3100 are software configurable. Configuration changes are made
by setting bits in control registers after the board is installed in a system.
Jumpers/switches are used to control those options that are not software configurable. These
jumper settings are described further on in this section. If you are resetting the board jumpers
from their default settings, it is important to verify that all settings are reset properly.
1.4.1 MVME3100 Layout
Figure 1-2 on page 26 illustrates the placement of the jumpers, headers, connectors, switches,
and various other components on the MVME3100.
There are two switch blocks which have user-selectable settings. Refer to Table 1-2 , Table 1-3 ,
and Table 1-4 for switch settings. There is one switch on the MVME721. Refer to Table 1-5 and
Table 1-6 for switch settings.