Artesyn MVME3100 Single Board Computer Installation and Use (June 2014) - Manual (Page 139)

Appendix A
MVME3100 Single Board Computer Installation and Use (6806800M28E) 139
A
Specifications
A.1 Power Requirements
In its standard configuration, the MVME3100 requires +5 V for operation. On-board converters
supply the processor core voltage, +3.3 V, +1.8 V, and +2.5 V. For any installed PMC card that
requires +12 V or -12 V, these voltages must be supplied by the chassis.
Table A-1 provides an estimate of the typical and maximum current required from each of the
input supply voltages.
In a 3-row chassis, PMC current should be limited to 32 watts (total of both PMC slots). In a 5-
row chassis, the PMC sites can support a total of 50 watts.
A.2 Environmental Specifications
Table A-2 lists the environmental specifications, along with the board dimensions.
Table A-1 Current Requirements
Model Power
MVME3100
No PMCs or peripherals attached Typical: 4.5 A (22.5 W) @ +5 V.0
Maximum: 5.6 A (28 W) @ +5.0 V
Table A-2 MVME3100 Specifications
Characteristics Specifications
Operating Temperature 0° to +55° C/32°F to 131°F or (inlet air temperature with forced air
cooling
Storage Temperature -40° to +85° C/-40°F to 185°F
Relative Humidity Operating: 5% to 90% non-condensing
Non-operating: 5% to 90% non-condensing
Vibration Operating: 6 Gs RMS, 5-200 Hz sine
Non-operating: 6 Gs RMS, 20-2000 Hz random
Physical Dimensions 6U, 4HP wide (233.4 mm x 160 mm x 19.8 mm) (9.2 in. x 6.3 in. x
0.8 in.)
Weight 468 g/16.5 oz. (IEEE handles)
MTBF 122,480 hours (calculated based on MIL-HDBK-217F Notice 1)