AMETEK 2001RP - Manual (Page 20)

User and Programming Manual - Rev R
10 2001RP
2.9 Available Options
2
Option Description
-AV Avionics version: 2001RP-AV
• 115 V
RMS
/ 230 V
RMS
volt ranges
• 17.4 / 8.7 Amp RMS maximum current
• Frequency range limited to 360 Hz minimum.
This unit may have been factory set to fixed frequency and single
voltage range. The frequency range and voltage range setting
can be queried over the bus if the –OP1 option is installed.
This option cannot be combined with option –LZ and must be
specified on the original order.
-L22 Locking knobs. Prevents front panel change of voltage and
frequency.
-LZ Low Impedance version: 2001RP-LZ
• 135 V
RMS
/ 270 V
RMS
volt ranges
• 14.8 / 7.4 Amp RMS maximum current
• Frequency range limited to 500 Hz maximum.
This unit is suitable for EN 61000-3-2 Harmonics test applications
and may also be used with optional PACS-1RP2 with calibrated
EN 61000-3-3 Flicker reference impedance for Flicker testing.
This option cannot be combined with option –AV and must be
specified on the original order.
-OP1 Option package 1 includes:
• Measurement Functions
• Combined IEEE-488 / RS232C interface.
• Remote Inhibit Input
• Function Strobe Output
-RMS Rack mount slides
P/N 211045 / Option -RMS
General Devices Model C300S-120-B308
See next page for rack mount slide position.
2
Additional options may have been made available since this manual revision. Installed options are listed on
the power source’s type sticker. A manual addendum may be issued for new options not covered by this
manual.