AMETEK 2001RP - Manual (Page 117)

User and Programming Manual - Rev R
2001RP 107
10.9.7 *SAV
This command stores the present state of the AC source to a specified location in memory.
The RP Series offers eight non-volatile memory locations for storing instrument setups.
Command Syntax *SAV
Parameters 0 through 7
Related Commands *RCL *RST
10.9.8 *SRE
This command sets the condition of the Service Request Enable Register. This register
determines which bits from the Status Byte Register (see *STB for its bit configuration) are
allowed to set the Master Status Summary (MSS). A 1 in any Service Request Enable
Register bit position enables the corresponding Status Byte Register bit and all such enabled
bits then are logically OR-ed to cause Bit 6 of the Status Byte Register to be set. See Section
12 for more details concerning this process.
When the controller conducts a STB? command, the MSS bit is not cleared. When *SRE is
cleared (by programming it with 0), the source cannot generate an MSS bit.
Command Syntax *SRE
Parameters 0 to 255
Default Value 128
Example *SRE 255
Query Syntax *SRE?
Returned Parameters (Register binary value)
Related Commands *ESE *ESR