AMETEK 2001RP - Manual (Page 109)

User and Programming Manual - Rev R
2001RP 99
10.7 Display Subsystem
DISPlay:MODE
This command is used to control the right hand side AC source display. The command will
allow the multifunction LCD display to switch between display of frequency, current, peak
current, power or power factor data.
The encoding for the mode command is as shown in the table below,
Parameter Value
Frequency 1
Current 2
Peak Current 3
Power 4
Power Factor 5
Table 10-1: Mode Command Encoding
Command Syntax DISPlay:MODE
Parameters 1 | 2 | 3 | 4 | 5
*RST Value 1
Examples DISP:MODE 2
Query Syntax DISPlay:MODE?
Returned Parameters
Related Commands none