AMETEK 2001RP - Manual (Page 16)

User and Programming Manual - Rev R
6 2001RP
2.3 System Specification
Parameter Specification
Setup storage Eight non volatile front panel setup registers available through
interface. Power on setting register available from front panel.
Interface (Option package -OP1 required)
RS-232C Bi-directional serial interface
Rear panel connector: 9 pin D shell
Handshake: CTS, RTS
Data bits: 8
Stop bits: 1
Parity: None
Baud rate: 19200
Command syntax: IEEE 488.2 commands and SCPI
IEEE-488 GPIB Interface
Rear panel connector: 24 pin D-shell
IEEE address: set using DIP switch on rear panel from
0 to 31
IEEE functions: SH1, AH1, T8, L4, RL2, SRQ 0 , PP 0 ,
DC 0 , DT 0 , C0
Terminators: LF, CRLF, EOI
Command syntax: IEEE 488.2 commands and SCPI
Remote Inhibit (Option package -OP1 required)
Rear panel connector: BNC
Input Contact closure to ground or logic low TTL
signal required to turn off output.
Automatic recovery when RI signal is
removed.
Function Strobe (Option package -OP1 required)
Rear panel connector: BNC
Output Active low TTL signal. Signal driven low for
approximately 400
µsec any time output
voltage or frequency programmed value
changes. Signal level may be changed by
removing jumpers to open collector.