WaveWare Adaptive AlphaNet - Manual (Page 16)

How to change a sign’s serial address
16 2 — Installing AlphaNET™ 3.0 software and setting up sites
Changing a sign’s serial address
1. T
o change the address of a particular sign, first make sure that sign
is connected to a power supply and is functioning.
2. P
oint the front of the remote control at the sign’s infrared receiver
window as shown below:
3. P
ress the button on the remote control.
PROG TEXT FILE A will appear on the sign.
4. N
ext, press the button until SET ADDRESS appears.
5. P
ress the button until ADDRESS = 00 appears. (The sign
may have an address other than 00.)
6. S
et the sign’s address by pressing any of the number keys. For
example, to enter an address of 15, press the button and then
the button.
7. F
inally, press the button two times to set the sign’s new
address.
N O T E
For some signs, like the 9000
series, AlphaVision
™
,
AlphaPremiere ™ , and
AlphaEclipse ™ displays, internal
DIP switches must be set to
change the serial address.
The person using the remote control should be from
5 to 30 feet from the front of the sign.
Y Z
S T U V W X
M N P Q R O
G H I J K L
A B C D E F
1 2 3 4 5 6
7 8 9 0
SPACE
AUTO SPEED TIME DOT
ROLL WIPE SCROLL FLASH HOLD ROTATE
SELECT
APPEND CURSOR SPECIAL FONT WIDTH COLOR
PROGRAM RUN
ON - OFF SOUND
RETURN
SHIFT CAPS SHIFT
INSERT BACK ADV DELETE
# ¢ $ % & *
< > = / + -
; : ” ’ , .
? !
Remote control
(front and top views).
Point the front of the remote control at the
sign’s infrared receiver window.
PROGRAM
BACK
ADV
A d d r e s s N o t e
Normally, a sign’s address is a
decimal number from 00 to 99.
However, if you need more
addresses, a hexadecimal
number from 00 to FF (0 to 255)
can be used as an address. For
example, hexadecimal 1F =
decimal 31.
1
5
RUN