CIRCUTOR CVM-C10 Series - Manual (Page 52)

 Programming the latch
The interlocking is selected on this screen, i.e., if the alarm is
interlocked after it has been tripped, even when the condition that
triggered it has disappeared.
Press key
for 3 seconds to edit the selection. The prog icon
will be displayed on the bottom of the screen.
Press key
to browse the two options (Yes and No).
To validate the data, press for 3 seconds and the prog icon will disappear from the display.
Press key to access the next programming step.
Note: If the unit is reset, the status of alarms is deleted and all alarms will return to the
programmed standby status, provided that the condition that triggered them has been resolved.
 Programming the time delay 2
The alarm disconnection delay is programmed on this screen in
seconds.
Press key
for 3 seconds to edit the maximum value selection.
The prog icon will be displayed on the bottom of the screen.
To enter or modify the value, press the key repeatedly,
increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to modify the other values.
If you press the key after changing the last digit, it will jump back to the first digit so you
can modify the previously programmed values again.
To validate the data, press for 3 seconds and the prog icon will disappear from the display.
Press key to access the next programming step.
52
CVM-C10
Instruction Manual