CIRCUTOR CVM-C10 Series - Manual (Page 25)

4.3.- DISPLAY
The unit has a backlit LCD display showing all the parameters listed in Table 3 .
The display is divided into four areas ( Figure 14 ):
Figure 14: CVM-C10 Display areas
 The area with data per phase displays the instantaneous, maximum and minimum
values of each phase being measured or calculated by the unit.
The total data area displays the totals of the values being measured or calculated by
the unit.
 Analogue bar, displays the % of the current power of the installation.
 Cos φ - PF Bar , displays the value of the system's Cos φ or power factor in real time.
4�3�1� COS φ - PF (POWER FACTOR) BAR
Figure 15: Cos φ - PF Bar
This bar displays the value of the installation's cos φ or power factor in real time.
The parameter that will be displayed is selected on the programming menu. ( “4.9.13. Selecting
the Cos φ - PF bar on the display” )
25 Instruction Manual
CVM-C10