Selecting the operation profile, Selecting the op, Eration profile – CIRCUTOR CVM-C10 Series User Manual
Page 42

4.9.11. Selecting the operation profile
The unit's operation profile is selected on this screen.
Press key
for 3 seconds to edit the operation profile
selection. The
prog icon will be displayed on the bottom of the
screen.
Press key
to browse the three profile options:
Analyzer profile,
analyzer,
Electrical energy efficiency profile,
e
3
,
User profile,
user,
To validate the data, press
for 3 seconds and the
prog icon will disappear from the display.
Press key
to access the next programming step
Selecting the screens that will be displayed (User profile)
The following screen is displayed if you have selected the
user profile:
This screen is used to select whether the unit's display screens
are defined by the user or not.
Press key
for 3 seconds to edit the selection. The
prog icon
will be displayed on the bottom of the screen.
Press key
to browse the two profile options:
the display screens are those that were stored in previous programming
settings of the unit. (In the case of new units, these will be the same as those of the
analyzer profile)
, the display screens are selected.
To validate the data, press
for 3 seconds and the
prog icon will disappear from the display.
Press key
to access the next programming step
42
CVM-C10
Instruction Manual