BINDER MK 115 - Manual (Page 56)

MKF + MKFT (E3.1) 07/2014 page 56/114
9.3 Entering the humidity values
08:43:59 15.12.13
Prog. Select.
Prog 1 PROG 01
Prog 2 PROG 02
Prog 3 PROG 03
Prog 4 PROG 04
Prog 5 PROG 05
Prog 6 PROG 06
Prog 7 PROG 07
Prog 8 PROG 08
Prog 9 PROG 09
Prog 10 PROG 10
Prog 11 PROG 11
Prog 1 PROG 01
TP- Program 2
TP- Program 3
TP- Program 1
Select the second subroutine “ TP-Program 2” and confirm by pressing ENTER. A program table will ap-
pear, which is initially empty until you enter the humidity values. You can now enter the humidity program.
Humidity at the beginning of
the program section
Fan speed in %
(no function)
Program No. Subprogram TP-Program No. 2
Total number of program
sections
Parameter set (preselected)
Tolerance band limits humidi-
ty (maximum and minimum
humidity) Operationlines (no function)
Duration of program
section
Number of start section in case
of repeat cycles
Number of repeats in case of
repeat cycles
Further proceeding is equivalent to the temperature value entry described in chap. 9.2.
The entry of a humidity set-point 0 % r.H. permits completely turning off humidity in defined
program sections and thus attaining faster temperature changes.
Time course of the subroutines
When starting the overall program, both subroutines (TP-Program 1 and TP-Program 2) run off synchro-
nously. They should be of the same duration because each of the subroutines becomes inactive after run-
off (i.e., no heating or refrigeration, switching states of the operation lines OFF, and the fan is off after ZP
1 is completed, no humidification after ZP 2 is completed). When the complete program is finished, the
controller changes to Idle Mode. Temperature and humidity proceed towards ambient values.
Performance after completing the program:
The controller changes to Idle Mode. Heating, refrigeration, and humidification are inactive; the chamber
approximates ambient temperature.
The fan is off. The switching states of the operation lines are OFF.
08:43:55 15.12.13
2