BINDER MK 115 - Manual (Page 54)

MKF + MKFT (E3.1) 07/2014 page 54/114
9.2 Entering the temperature values and the switching states of the operation
lines
Select the first subroutine “ TP-Program 1” and confirm with ENTER.
A program table will appear, which is initially empty until you enter the temperature values. You can now
enter the temperature program.
Temperature at the beginning
of the program section
Fan speed in %
(no function)
Program No. Subprogram TP-Program No. 1
Total number of program
sections
Parameter set (preselected)
Tolerance band limits tem-
perature (maximum and min-
imum temperature)
Operation lines
(1= bedew protection)
Duration of program
section
Number of start section in case
of repeat cycles
Number of repeats in case of
repeat cycles
You can enter Program sections into this program table.
Press the “PGM” button. An inquiry display appears allowing you to enter or delete individual program
sections:
ZP-Abschnitt Abs. Nr. 5
insert
delete
In this view, new program lines can be entered or deleted:
new New lines are added below in the table
insert New lines are added above a previously selected line
delete Individual lines that have been selected previously are deleted
Create as many lines, i.e. program sections, as desired. As a next step, you can enter values into these
lines. It is possible to add supplementary lines later or to delete individual lines at any time.
To enter values, select the corresponding line via the
arrow keys.
Press the ENTER button. The
program editor ap-
pears.
PGM
08:43:55 15.02.02
PGM
08:43:55 15.12.13
08:43:55 15.12.13
08:43:57 15.12.13
Prog. Select.
Prog 1 PROG 01
Prog 2 PROG 02
Prog 3 PROG 03
Prog 4 PROG 04
Prog 5 PROG 05
Prog 1 PROG 01
TP- Program 2
TP- Program 3
TP- Program 1