BINDER MK 115 - Manual (Page 27)

MKF + MKFT (E3.1) 07/2014 page 27/114
3. Completeness of delivery, transportation, storage, and installa-
tion
3.1 Unpacking, and checking equipment and completeness of delivery
After unpacking, please check the unit and its optional accessories, if any, based on the delivery receipt
for completeness and for transportation damage. Inform the carrier immediately if transportation damage
has occurred.
The final tests of the manufacturer may have caused traces of the shelves on the inner surfaces. This has
no impact on the function and performance of the unit.
Please remove any transportation protection devices and adhesives in/on the unit and on the doors and
take out the operating manuals and accessory equipment.
Remove the upholstered transport piece (L-type profile)
from the lower door locking and keep it for possible later
transportation.
Figure 7:
Door locking with transport piece (state of delivery)
CAUTION
Sliding or tilting of the unit.
Damage to the unit.
Risk of injury by lifting heavy loads.
∅
Do NOT lift or transport the unit using the door handle, the door or the lower housing.
∅ Do NOT lift the unit by hand.
 Keep the unit in upright position.
 Lift the unit from the pallet using technical devices (fork lifter). Set the fork lifter only
from the rear in the middle of the unit. Make sure to place all the lateral supports of the
unit on the forks.
If you need to return the unit, please use the original packing and observe the guidelines for safe lifting
and transportation (chap. 3.2).
For disposal of the transport packing, see chap. 18.1.
Note on second-hand units (Ex-Demo-Units)
Second-hand units are units that have been used for a short time for tests or exhibitions. They are thor-
oughly tested before resale. BINDER ensures that the chamber is technically sound and will work flaw-
lessly.
Second-hand units are marked with a sticker on the unit door. Please remove the sticker before commis-
sioning the unit.