Altera Arria 10 Avalon-MM DMA User Manual
Page 57
Table 5-18: Status and Link Training Signals
Signal
Direction
Description
cfg_par_err
Output
Indicates that a parity error in a TLP routed to the internal
Configuration Space. This error is also logged in the Vendor
Specific Extended Capability internal error register. You must
reset the Hard IP if this error occurs.
derr_cor_ext_rcv
Output
Indicates a corrected error in the RX buffer. This signal is for
debug only. It is not valid until the RX buffer is filled with data.
This is a pulse, not a level, signal. Internally, the pulse is
generated with the 500 MHz clock. A pulse extender extends the
signal so that the FPGA fabric running at 250 MHz can capture
it. Because the error was corrected by the IP core, no Application
Layer intervention is required.
(3)
derr_cor_ext_rpl
Output
Indicates a corrected ECC error in the retry buffer. This signal is
for debug only. Because the error was corrected by the IP core,
no Application Layer intervention is required.
(3)
derr_rpl
Output
Indicates an uncorrectable error in the retry buffer. This signal is
for debug only.
(3)
dlup
Output
When asserted, indicates that the Hard IP block is in the Data
Link Control and Management State Machine (DLCMSM) DL_
Up state.
dlup_exit
Output
This signal is asserted low for one
pld_clk
cycle when the IP
core exits the DLCMSM DL_Up state, indicating that the Data
Link Layer has lost communication with the other end of the
PCIe link and left the Up state. When this pulse is asserted, the
Application Layer should generate an internal reset signal that is
asserted for at least 32 cycles.
ev128ns
Output
Asserted every 128 ns to create a time base aligned activity.
ev1us
Output
Asserted every 1µs to create a time base aligned activity.
hotrst_exit
Output
Hot reset exit. This signal is asserted for 1 clock cycle when the
LTSSM exits the hot reset state. This signal should cause the
Application Layer to be reset. This signal is active low. When this
pulse is asserted, the Application Layer should generate an
internal reset signal that is asserted for at least 32 cycles.
(3)
Altera does not rigorously test or verify debug signals. Only use debug signals to observe behavior. Do
not use debug signals to drive custom logic.
5-16
Reset, Status, and Link Training Signals
UG-01145_avmm_dma
2015.05.14
Altera Corporation
IP Core Interfaces