Spectrum Controls 1756sc-OF8H Series A - Manual (Page 65)

Chapter 6: 1756sc-OF8H Channel Configuration, Data, and Status 51
Configuration, Data, Configuration, Data, Configuration, Data, Configuration, Data, Configuration, Data,
and Sta and Sta and Sta and Sta and Status tus tus tus tus TTTTTaaaaags gs gs gs gs
for the 1756sc-OF8H for the 1756sc-OF8H for the 1756sc-OF8H for the 1756sc-OF8H for the 1756sc-OF8H
Read this chapter to:
• Send configuration data to the module
• Configuration tags
• Input tags
• Output tags
• Accessing the module tags
• Changing configuration information at the tags
This chapter outlines the detailed settings for the 1756sc-OF8H. These
settings determine the modules input types, scan rates, and various
attributes. Detailed descriptions of these settings are available in the Tag
Definition section of this chapter.
Note: The following format is used to describe tags
Tag Name Data Type Style Description
S e n d S e n d S e n d S e n d S e n d
C o n f i g u r a t i o n C o n f i g u r a t i o n C o n f i g u r a t i o n C o n f i g u r a t i o n C o n f i g u r a t i o n
Data to the Data to the Data to the Data to the Data to the
M o d u l e M o d u l e M o d u l e M o d u l e M o d u l e
After changing the configuration tags in this chapter you must then send
them to the module. To do this you may perform any of these operations:
1. Inhibit then un-inhibit the module via the module properties dialog,
Connection Tab
2. Reset the module via the modules properties dialog. Module Info tab.
3. Reset the module via ladder logic. See the “DoReset” rung in the
sample ladder located in Chapter 8.
4. Perform a “Set Attribute All” or Module Reconfigure message
instruction via ladder logic. Refer to Chapter 8 for information about the
“DoSetAttrAll” command.
Note: If an invalid configuration is sent to the module a connection error
will occur. See chapter 9 for a list of error codes.
Chapter 6