Spectrum Controls 1756sc-OF8H Series A - Manual (Page 22)

8 ControlLogix ™ Analog HART Modules
Using your module in
the ControlLogix
System
Place your module in any slot of a ControlLogix chassis or modular
expansion chassis.
An analog I/O module translates an analog signal into or from a
corresponding digital representation which controllers can easily operate
on for control purposes.
A ControlLogix I/O module mounts in a ControlLogix chassis and uses a
Removable Terminal Block (RTB) to connect all field-side wiring.
Before you install and use your module you should have already:
· installed and grounded a 1756 chassis and power supply.
· ordered and received an RTB for your application.
Important: RTBs are not included with your module purchase.
Specify Allen Bradley Part Number:
1756sc-IF8H - 1756-TBCH - 36 position screw terminals
1756-TBS6H - 36 position press terminals
1492-AIFM8-3
1492-ACABLE-UC (Differential Voltage)
1492-ACABLE-UD (Differential Current)
1756sc-OF8H - 1756-TBNH - 20 position screw terminals
1756-TBSH - 20 position press terminals
1492-AIFM8-3
1492-ACABLE-WB
Module Installation and
Removal
When installing the module in a chassis, it is not necessary to remove the
terminal blocks from the module. However, if the terminal blocks are