Pitney Bowes RISO ComColor Printer - Manual (Page 34)

32
2
Load the paper.
Load paper with the printing side face-up.
• If you load many sheets at a time, you cannot
adjust the paper guides. (Sheets are not in neat
order because they are bent or bumpy.) Separate
sheets into several loads. If you load many sheets
at a time, see “If you load many sheets at a time”.
• To load envelopes, leave their flaps open and
load them so that they will be fed from the
bottom. Use the envelope guide angle
adjustment lever to adjust the inclination angle
of the envelope guide. Adjust the feeding
pressure according to the quality of envelopes
you use. For adjustment, use the envelope guide
feeding pressure adjustment lever. Lift the lever
and slide it. Refer to the seals near the lever, and
perform a setting suitable to your envelopes.
Level this
surface
Envelope Guide Paper Feed
Pressure Adjustment Lever
Envelope Guide Angle
Adjustment Lever
Thick Envelopes
Thin Envelopes
Thin Envelope and
Paper
Thick Paper and
Long Envelope
Paper Other
Than Envelope
3
Adjust the paper guides so that they will be suitable
for the paper size.
Move the guides against the edges of the paper, lock the
paper guides lever to fix the guides in place.
4
Adjust the feeding pressure adjustment lever.
Set it to “Standard” for normal use, and set it to “Card” for
thick paper, special paper, etc.
5
Check the tray setting on the touch panel.
Set [Feed tray] for paper size and type. After changing the
type of paper to load, be sure to change the [Feed tray]
setting.
If you load many sheets at a time
1
Spread the guides and load approximately 500
sheets in the standard tray.
2
Adjust the paper guides so that they will be suitable
for the paper size.
Move the guides against the edges of the paper, lock the
paper guides lever to fix the guides in place.
3
Load the rest of sheets.
After loading all the sheets, perform the normal setting.
Follow steps 4 and 5 in “Loading Paper”.
ComColor Series Basic Guide 02