Kipp&Zonen LOGBOX SD Data Logger - Manual (Page 44)

44
P[X][Y]
(X represents indexed nr. of polynomial, Y represents coefficient. Y[any real number])
Set up coefficients of polynomial
15.1.1 P40
=0
OK
>P41
P41
=10000
OK
>P42
P42
=125E-7
OK
>P43
P43
-321.245
OK
P?
Returns all coefficients of all polynomials
P?
1: 0 2.25 0.0009813 0
2: Not set.
3: Not set.
4: 0 10000 125E-7 –321.245
5: Not set.
6: Not set.
7: Not set.
8: Not set.
OK
Other configuration commands
LE
Clear all settings for logging
L[X]1
(X represents analog or digital input. X[1...9, A, B, C])
Enable logging of input X
L[X]0
(X represents analog or digital input. X[1...9, A, B, C])
Disable logging of input X
LMC
Sets logging memory to circulate. If the memory is full, it will overwrite the oldest logs.
LMS
Sets logging memory to stop if the memory is full.
D[X]
(X [0...9])
Set delay for x seconds
Q
Quit service mode
In service mode you can go to SD card setup by pressing S command.
In SD Card Setup there are following commands: