Kipp&Zonen LOGBOX SD Data Logger User Manual
Page 14
14
Last step is to connect the (supplied) serial cable RS232 with the computer. The LOGBOX SD
software can be used to setup the logger and related sensors. Or setup your communication
software on your computer (e.i. HyperTerminal) for standard speed 115200bps, 8 data bits,
1 stop bit, parity none and handshaking none. Then you will see measured data from
LOGBOX SD.
LOGBOX SD is ready to operate. Depending on saved configuration LOGBOX SD performs
measurement, logging and printout of measured data on serial line, which can be seen on
the computer. Setting up the hardware and software configuration is described in the
next chapters.