Kipp&Zonen LOGBOX SD Data Logger - Manual (Page 42)

42
FINAL SDWritting = 1 minutes
J
Setup file close interval on SD card
J
You can use the following SD card FILE_CLOSING intervals:
10 20 30 minutes, 1, 2, 3, 4, 5, 6, 12, 24 hours and Always
Switch between them by and confirm by
If you type you will roll over mentioned intrevals. If you will type you will receive
following response
FINAL SdFileClose = 24 hours
l
Type all data in memory
l
2004-11-27 10:46:03 55.778 61.274 61.268 / / / 0.888 0.785 / / / /
2004-11-27 10:47:03 55.781 61.284 61.288 / / / 0.745 0.705 / / / /
2004-11-27 10:48:03 55.773 61.329 61.333 / / / 0.637 0.640 / / / /
2004-11-27 10:49:03 55.771 61.188 61.178 / / / 0.667 0.633 / / / /
Q
Quit service mode
To access configuration commands, you will need to type space in service mode. Then you have
available following configuration commands:
Analog inputs configuration commands
AE
Clear all settings for analog inputs
AG0
Disable 24 bit resolution measurements
AG1
Enable 24 bit resolution measurements
AGP
Enable ratio measurement of A2 to A1
AGp
Disable ratio measurement of A2 to A1
AGQ
Enable ratio measurement of A3 to A1
AGq
Disable ratio measurement of A3 to A1
A[X]W7 (X represents analog input. X [1...5])