EXFO FG-750 - Manual (Page 188)

Operating Your RTU in OTDR Measuring Mode
174 FG-750
Performing a Test
To perform a test:
1. From the main menu, select Configuration > Optical Routes.
2. From the tree view, select the route containing the test setup you want
to use for your test.
3. From the tree view, select Test Setups.
4. From the tree view, select the test setup you want to use for your test.
5. Click Start Test.
The test is sent to the test queue, waiting to be performed.
Note: If there was a fault before you started the test, this fault will be cleared and
re-created (fault status will be set as New) if it is still present.