EXFO EXpert VoIP Test Tools - Manual (Page 36)

Test Setup
30 EXpert VoIP Test Tools
Configuration (SIP)
Destination IP address
Only available when the Peer Device is set as EXFO Device.

Manually Configure IP allows to configure the destination IP address
manually.

Auto Discovery List allows to select the IP address from a list of IP
addresses discovered by the EXpert VoIP Test Tools.

IP address allows to either enter the IP address manually (from 0.0.0.1
to 223.255.255.255) or from a list.
Utilities

Capture check box when selected (cleared by default) captures the
RTP packet stream for the running test. Once test is completed, the
capture file is available and can be opened in the Wireshark
application from the Load/Save option; refer to Packet Capture on
page 87 for more information.

Record check box when selected (cleared by default) allows
recording network VoIP traffic. The recorded file can be listened from
the Load/Save option; refer to Record Audio Tab on page 87 for more
information. Record is only available for Live Call media type.
Capture Filters
Available when the Utilities - Capture check box is selected.

IP Address check box when selected (cleared by default) uses the
Peer IP Address that acts as a filter that will capture packets having the
source or destination IP address matching the specified Peer IP
address. The accepted range is from 0.0.0.1 to 223.225.225.225.

File Size represents the maximum size of the file to capture either in
megabytes (1 to 50 MB (default is  )) or in seconds (1 (default) to
3600 seconds).