Setting the sound parameters, Beat loop function – Akai MPC 2000xl User Manual
Page 120

Chapter 6: Creating and Editing Sounds
Page 109
Setting the Sound Parameters
This is for setting sound parameters such as the volume or pitch of the sound. It is also possible to
set the BEAT LOOP FUNCTION.
Holding SHIFT and press TRIM (or 5 on the numeric pad) and display the sound parameter screen
by pressing
PARAMS
[F4].
.........................................................
PLAY X
PLAY X
Level:100
Tune:
0
BEAT
Beat: 4
LOOP
Sample tempo=120.0
FUNCTION
New tempo=120.0
ZONE
LOOP
TRIM
PARAMS
Snd:
loop_1
PLAY X:ALL
PLAY X:ALL
•
Snd:
Use the DATA wheel to select the sound whose parameters you want to set.
•
Level:
Sets the volume of the sound. Set the value with the DATA wheel or use the numeric pad to
enter the number and then press ENTER.
•
Tune:
Sets the pitch of the sound. Changes made here will also change the length of the sound.
When
PLAY X
[F6] is pressed, you can play back the currently selected sound at full velocity
according to the settings in the
PLAY X:
field. For details refer to the “TRIM Mode”.
Beat Loop Function
You can set the BEAT LOOP FUNCTION in the right-hand section of the Sound Parameter
Screen.
.........................................................
PLAY X
PLAY X
Level:100
Tune:
70
BEAT
Beat: 4
LOOP
Sample tempo : 120.0
FUNCTION
New tempo : 120.0
ZONE
LOOP
TRIM
PARAMS
Snd:
loop_1
PLAY X:ALL
PLAY X:ALL
The BEAT LOOP FUNCTION is used to match the tempo of two phrase samples playing in a loop.
Phrases will start to slip out of sync when multiple phrase samples playing in a loop are played
back at different tempos. In order to solve this, it is necessary to change the pitch of each sample
to match the tempos.
Since the Beat Loop function calculates the loop bar length, this setting does not effect one-shot
(non-looped) sounds.
•
Beat:
Set the length of the looped phrase sample here (number of beats). For example, in a four
beat sample piece, if the length is four beats (one bar), enter 4.
•
Sample tempo:
This is related to the length of the sample. The original tempo of the sample is calculated
from the length of the sample and the number of beats set in the
Beat:
field.
•
New tempo:
The tempo of the sound is determined by the tune settings on the left. To match the tempo
with other sounds, refer to this field as you set the
Tune:
field on the left. To make the
tempo of the two phrases match, set the value of the
New tempo:
of each phrase
sample to be the same by adjusting the
Tune:
setting.