Loop mode – Akai MPC 2000xl User Manual
Page 112
Chapter 6: Creating and Editing Sounds
Page 101
LOOP Mode
Set the loop of the sound. Set to play loops, such as a phrase sample, in this mode.
Hold SHIFT and press TRIM (or 5 on the numeric pad), then press
LOOP
[F2].
•
To:
This sets the turn of the loop. Select the
To:
field with the cursor and change the value
with the DATA wheel. You can enter large numbers by entering a number with the numeric
pad and then pressing ENTER.
You can also use the NOTE VARIATION slider while holding the SHIFT key.
•
Lngth:/End:
This sets the length of the loop.
You can select either
Lngth:
or
End:
by placing the cursor here and turning the DATA
wheel.
Select the field to the right of
Lngth:/End:
with the cursor and change the value with
the DATA wheel. You can enter large numbers by entering a number with the numeric pad
and then pressing ENTER.
You can also use the NOTE VARIATION slider while holding the SHIFT key
Lngth:
this indicates the length of the loop between the
To:
and
End:
points.
End:
this indicates the
End:
point.
•
Loop:
This turns the loop ON or OFF.
Press
EDIT
[F5] to display the Fit to length window.
This function enables you to set the loop length to the same as that set in the TRIM mode. Press
DO IT
[F5] in the Fit to length window to execute this function.
By pressing
PLAY X
[F6], the currently selected sound will play back at full velocity according to
the settings in the
PLAY X:
field. For details refer to “TRIM Mode” section.
.........................................................
PLAY X
PLAY X
EDIT
LOOP
PARAMS
Snd:
loop_1
(ST) PLAY X:ALL
(ST) PLAY X:ALL
TRIM
ZONE
To:
105
Lngth:
85242
Loop:OFF
.........................................................
PLAY X
PLAY X
EDIT
LOOP
PARAMS
Snd:
loop_1
(ST) PLAY X:ALL
(ST) PLAY X:ALL
TRIM
ZONE
To:
105
End:
85242
Loop:OFF