Toa VM-3000 Series - Manual (Page 55)

55
10.4.3. Failure reset operation
Perform failure reset at the VM-3240VA, VM-3360VA, or RM-320F*, or by use of the control input.
Resetting failures causes all currently lit or flashing yellow Failure and Communications Failure indicators to
go out and returns the system to normal status. However, if the cause of the failure has not been remedied,
the system will again return to failure mode.
* Applicable only when all the versions of VM-3000VA firmware, VM-3000E firmware, and VM-3000 Setting
Software are 2.00 or later.
Cancel key
[Acknowledging failures by the control input]
Failure acknowledgment can also be performed by using the control inputs of the VM-3240VA, VM-3360VA,
VM-3240E, and VM-3360E. (Refer to "Event Settings" "General Control Input Settings" in the separate
software instruction manual.)
VM-3240VA/3360VA/3240E/3360E
Control input
Failure
acknowledgement Failure
reset