Real-time view options, Solid view, Spray boom view – TeeJet SmartPad II User Guide User Manual
Page 96: Real-time view options solid view spray boom view

3-42
Chapter 3 - Real-Time Guidance
About the Real-Time Guidance Process
SmartPad II
Software Version 4.03
Real-Time View Options
There are two real-time map view options, North Up and Course on Ground (COG). SmartPad II software versions
prior to 4.03 employ the North Up view only. These options are selectable via buttons in the real-time page button bar.
Solid View
Solid View paints a solid path where the application is taking place. To change between solid view and spray boom
view select the tool icon (swiss army knife) and locate the spray boom button. The spray boom button when pressed
will begin to paint a path until the spray boom button is pressed again to turn the application off. NOTE: If status
detect is being used the spray boom button will automatically be activated with the master switch. See
Figure 3-53 to for an illustration of the Solid View with the option of switch to Spray Boom View. Select the Tool but-
ton as shown in the left image of Figure 3-53.
Spray Boom View
Spray Boom view drops bars resembling the width of the spray boom where the application is taking place. To change
between spray boom view and solid view select the tool icon (swiss army knife) and locate the spray boom button.
The spray boom button when pressed will begin to paint a path until the spray boom button is pressed again to turn
the application off. NOTE: If status detect is being used the spray boom button will automatically be activated
with the master switch. See Figure 3-54 to for an illustration of the Spray Boom view with the option of switch to
Solid View. Notice in the image on the right in Figure 3-54 that the Spray Boom button is applying and bars are
dropped.
Figure 3-53: Solid View
Figure 3-54: Spray Boom View