TeeJet SmartPad II User Guide - Manual (Page 48)

2-26 Chapter 2 - Software Overview
SmartPad II Tools
Fieldware for Smartpad II
Software Version 4.03
GPS Logger
The GPS Logger tool is used to log and store the GPS coordinates during a session. This tool would be used to create
a.raw file that could be ran using Mid-Tech’s GPSsim program to simulate a live GPS input. The most common use of
this feature is to simulate GPS to a SmartPad II system without moving.
To use this tool select the Data Logger menu and create a Log File name see Figure 2-27. Once a name is created
select go and begin to drive. As the vehicle moves the location is being stored to the Log File. NOTE: If the operator
stops moving the systems does not stop recording GPS coordinates.
Figure 2-27: Data Logger Setup