Status detect – TeeJet SmartPad II User Guide User Manual
Page 64

3-10
Chapter 3 - Real-Time Guidance
Guidance Setup
SmartPad II
Software Version 4.03
Status Detect
The Status Detect menu item is used to auto detect vehicle boom status. When Status Detect is properly implemented,
SmartPad II will detect when product delivery is on or off based on the vehicles master boom switch. This will elimi-
nate the need to press the spray on and spray off software button in the SmartPad II software during guidance. This is
accomplished by connecting the status detect wires to vehicle boom control switch.
To change the Status Detect setting; highlight the Status Detect menu item and press
. The Status Detect dialog
box will appear. Select 1 Section. Currently this is the only available selection, then press
to return back to the
Guidance setup menu.
With Status Detect set to off, as applied data can still be recorded by using the Applied On/Off button in the SmartPad
II real-time button bar.
Figure 3-12: The Status Detect Menu Item
Setting
Description
OFF
No Status Detect implemented. Default setting.
1 Section
Status detect will assume a single swath centered on the
vehicle.
Table 3-2: Status Detect Settings