Potter PFC-9000 Series - Manual (Page 87)

87
PFC-9000 • 5403535 • REV G • 9/08
Appendix F – Programming the UDACT-9100
Note: Command Menu feature 9 can only be accessed if jumper JW2 is placed on the main board, see Table 3.
Dialer Config (Command-Menu):
The following illustration shows the dialer configuration menu. Each item in this menu is described below in detail.
Use the Up and Down keys to scroll through the menu and press the Enter key to make a selection. To exit from the
menu, select the Exit menu option and then press either the Enter or Cancel key. Once a menu feature has been
selected, use the Left and Right keys to change values or the numerical keys to enter account numbers.
1. Account Info Menu
Command Menu/Dialer Config/Account Info
1.Account# 1 Identification
123456->Default
Use this function to set the Account ID for the
monitoring station to which the dialer reports
events. The maximum number of digits
allowed is six. For contact ID, only the first
four digits are used; the last two are truncated.
If you are using the Contact ID protocol, the
allowed digits for the account ID are simple
digits 0 to 9 and hexadecimal digits A to F. The
SIA protocol only allows digits 0 to 9.
To enter hexadecimal digits, press the INFO
button. The letter “A” will appear. To scroll
through the rest of the letters, press INFO
repeatedly. Press # key to move the cursor to
the right or press * key to move it to the left.
Command Menu/Dialer Config/Account Info
2.Account#1 Telephone Number
101 ->Default
Use this function to set the telephone number
of the monitoring station. The maximum
number of digits allowed is 19 including
commas “,” and numerals. The commas will
be treated as 1 sec delay. To enter a comma
“,” press the INFO button. Press the # key to
move the cursor to the right or press the * key
to move it to the left. An example of a typical
telephone number is 9,,1234567008, 9 being
the dial out where required.
- Dialer Config -
1 Account Info
2 Telephone Line
3 Report Options
4 Time Parameter
5 Enable/Disable
6 Ring Detection
1 A c c o u n t # 1 I D
2 A c c o u n t # 1 T el
3 A c c n t # 1 F o r m a t
4 A c c o u n t # 2 I D
- A c c o u n t I n f o -
5 A c c o u n t # 2 T e l
6 A c c n t # 2 F o r m a t
Account#1 ID:
123456
Account#1 Telnum:
101