Potter PFC-9000 Series - Manual (Page 70)

70
PFC-9000 • 5403535 • REV G • 9/08
Similar to the ZA-9008, the notification and relay circuit adder cards are easily added and modified during the initial set-up. The
notification card must have the inputs selected as strobe or signal. In addition, each circuit should be selected as silenceable/
deactivatable during installation. The output circuit adder cards, IDC-9004 and the AMR-9008, can be correlated to the input
circuits in the correlations section on pages 81 and 82.
Adding Annunciators
The annunciators must be added to Loop 0. The Loop 0 must
be highlighted and then select add from the Item menu. The
annunciator will default for the RA-LCD, however the RA-
LED is available in the drop down box. The Tag line is to
put a tag on the device to differentiate it in the configuration
software. The tag line can only be added when the annunciator
is added, it cannot be changed once the annunciator is added.
When an annunciator is added it is displayed under the base
panel as either LCD Annunciator or Remote Annunciator.
The system can support up to eight annunciators of either RA-
LCD, RA-LED 32, PGD 32 or a combination thereof.
To modify the Display or Access Levels, highlight Annunciator
and select Modify.