Potter PFC-9000 Series User Manual

Page 50

PFC-9000 • 5403535 • REV G • 9/08

Clear Event Log

This control allows the user to select the log that they wish to clear: Alarm, Event or All. Select the Clear Event Log and enter the

pass code if necessary.

- Select Log -

1 Alarm Log

2 Event Log

3 All Logs

Once the log is selected push the ENTER button. The panel will query the user to verify that they want to clear that log. If you are

sure, push the ENTER button, if not push the CANCEL button.

Clear Verification Count

The Clear Verification Count clears the log of the verified alarms received. The Clear Verification Count may require a pass code

if one is installed.

Auto Program

Once all of the devices have been uniquely addressed and installed, the user can utilize the Auto Program feature to quickly

program all of the devices into the panel, or when new devices are added to the system they can quickly be added. In addition,

the Auto Program creates a fail-safe system in which every new input is configured as an alarm input and they are automatically

correlated to every output including notification circuits and the alarm relay. The panel can be auto programmed and then the

program downloaded to a computer for device mapping and sensor adjustment.

The Auto Program feature will not program the annunciators into the system. The annunciators must be programmed using the

computer software. If the panel has a trouble that includes an annunciator with a data link trouble or version mismatch, the Auto

Program will abort.

Potter strongly recommends that the Auto Program feature have at least a level 2 pass code protection.

Press the button, the display will read

-Command Menu-

1 Reports

2 Bypass

3 Walktest v

Press the Scroll Up arrow until #9 “Autoprogram”

Press the button, the display will ask for a passcode of level 2 or higher. The factory default

passcode is 2222 which is the TROUBLE QUEUE button four times.

The display will indicate X number of new devices found on loop Y, add with default programming? Y

Press the button.

The display will read WARNING System must be Thoroughly Rechecked When Done, Continue? Y

Press the button.

The display will indicate that autoprogramming is in process.

NOTE: When the panel is finished all addressable modules that have been added to the panel through the autoprogram feature

default to a general alarm signal and are automatically mapped to all notification circuits.

ENTER