LAARS NeoTherm NTV (Sizes 150–285 MBTU/h) - Service Manual User Manual
Page 7
Service Manual NeoTherm 80 - NeoTherm 285
Table of Contents
Section A - Troubleshooting - Start Here
Sect. Title ................................................................................Page
A1
Troubleshooting - Start Here ............................................... 1
Unit Will Not Fire - Blower is Not Running ........................... 2
Blower Runs Continuously, No Display ............................... 4
Control Unit is in “Standby” Mode ........................................ 5
Changing Control Settings, Change Not Complete,
Original (White) User Interface ............................................ 7
Unit is Running, But Building is Still Cold ............................ 8
Control Unit Says “Run”, But Boiler is Not Firing ................. 9
Open Safety Interlock Chain - Fault #63 ............................ 9
Short-Cycling - Fault #61 ................................................... 10
Unit is Noisy ....................................................................... 10
Section B - Troubleshooting Procedures
Sect. Title
Page
Quick Check of Components in the
Safety Interlock Chain ....................................................... 11
Troubleshooting the 24V AC Power Supply ...................... 15
Checking the Safety Interlocks .......................................... 16
Checking the Low Water Cutoff Switch ............................. 18
Controller for Low Water Cutoff ......................................... 19
Low Water Cutoff Switch ................................................... 20
High Water Temperature Limit Switch ............................... 22
Checking the Flow Switch ................................................. 22
Testing the Flow Switch ..................................................... 23
Removing and Replacing the Flow Switch ........................ 24
Removing and Replacing the Gas Valve ........................... 26
Checking the Condensate Trap Water Level Switch ......... 30
Testing the Condensate Trap Level Switch ....................... 31
Removing and Replacing the Condensate Trap ................ 31
v